Car Forums  

Go Back   Car Forums > Technical Discussions > Repairs & Maintenance
FAQ Search Today's Posts Mark Forums Read

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 09-07-2012, 04:04 PM   #1
sean_hawn19
CF Newbie
 
Join Date: Mar 2005
Posts: 49
e-brake problem

I own an 04 accent 1.6l. My e-brake was working without issue. I had to change the back drum brake as they were low. Replace with drums, shoes, and spring set. Found I had a leaky wheel cylinder and ended up replacing both, as they are problematic on these cars. Put everything back together, readjusted the e-brake cable and adjuster wheel.

Now when I apply the ebrake, the handle gets stiff but does not stop the car at all. The cable moves freely and engages. My car only has a 2 piece cable line. ONe from either wheel that connects to the lever. Lines are not siezed or caught up and can see they engage when I remove the drums. Can see they get pushed out.

So what is going on? ANy ideas? Can the line be stretched and not apply them hard?

Thanks for any help. Like using it and knowing its there in case something happens.
sean_hawn19 is offline   Reply With Quote
 


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Forum Jump



All times are GMT +1. The time now is 01:17 PM.

Powered by vBulletin Version 3.5.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2002 - 2011 Car Forums. All rights reserved.