Originally Posted by BrianDingler
Would a chevy 350 fit into my 91 volvo 740? and if it will how much would the labor cost? Anything else i should know about this either like is it a stupied idea? etc.... thanks
I realize that this is a well overdue response, Brian but, I just ran up on it. I have been doing wierd swaps for over 40 years and this is one of the easiest ones to do. Use the engine/ tranny combo. If the Volvo is an automatic, the shifter is almost perfect. Get a Lincoln MIG welder from the eBay, set it for .023/.025 wire and practice a few days. You can make up everything you need. Take the front part of the driveshaft and a chevy front yoke assy. to a driveshaft shop....they'll "glue" it and balance it cheaper than a chevy half-shaft. The wiring diagrams can be found almost anywhere. $10 and most local independent shops will print you an All-data diagram for the chevy and Volvo.
OOps...gotta run get some meds before doc closes. IF you've already done it, I'm sure it's "nice", mine were real surprises to me and the public.